Weefselinspectie bij de fabricage van kleding

Voor de stofinspectie, kledingfabrikanten onderzoeken bij aankomst de materiaalvoorraad. Zo worden eventuele stofonregelmatigheden vroeg in het productieproces opgemerkt. Textielproducenten inspecteren stoffen materialen meestal voordat ze ze naar fabrikanten sturen.

General fabric inspection procedures

1. Finish fabric inspections in a very appropriate and safe setting with enough ventilation and correct lighting.
2. Stof die door het frame gaat, moet tussen 45-60 graden hoeken naar de inspecteur. En doe het op toepasselijke Cool White lichtgewicht twee F96 fluorescentielampen bovenop de kijkruimte. May use the backlight as and once required.
3. Fabric’s speed on examination machine should not be over fifteen yards per minute.
4. Do all cloth examination once eightieth of fine.
5. Standard approved bulk dye heap standards for all approved tons should be accessible before examination.
6. The approved commonplace of bulk dye heap should be accessible before beginning examination for assessing color, hand, Wat controleert AiT tijdens productinspectie?, construction, end and visual apparance.
7. Evaluate and document shade continuity at intervals a roll by checking shade variation between center and selvage and therefore the starting, middle, and finish of every roll.
8. Evaluate textiles like knits for weight against commonplace approved weight.
9. Check cloth dimension from selvage to selvage against the quality.
10. Flag all defects throughout examination.
11. Compare the length of every roll inspected to length as mentioned on provider ticketed tag. And any deviation should be documented and reported to mill for a further replacement to avoid a shortage.
12. If yard artificial or written materials square measure being inspected the repeat measure should be done from the start, middle and finish of elite rolls.

Why is fabric inspection important?

1. It is a crucial aspect before garment producing to avoid rejects due to cloth quality and round-faced with an sudden loss in producing.
2. The inspection is finished for fault/defect rate, cloth construction, cloth weight, shrinkage, finish to finish or edge to edge shading, kleur, Wat controleert AiT tijdens productinspectie?, length/width, print defect and apparance.
3. Fabric inspection ensures to minimize the rejection of cut panels or rejected clothes due to cloth faults. Cutting inspected and approved cloth ensures not solely finished garment quality however conjointly cut back rejects, improves potency and timely deliveries.