Cigireacht ar Suits Sneachta agus Cigireacht Suits Léim
Snow Suits Inspection and Jump Suits Inspection
Snow Suits and Jump Suits Measuring Guides
- Bust or Chest
Measure straight across chest, díreach faoi bhun armhole, ón taobhfhilleadh go dtí an taobh eile fillte. Bí cinnte an pleat lárchúl a shíneadh agus aon fhilleadh faoi armholes sula ndéantar é a thomhas. Tomhaiseann roinnt marcóirí / dearthóirí / allmhaireoirí 1 orlach faoi armhole.
- Waist
Measure straight across waist, ag pointe is cúinge, ón taobhfhilleadh go dtí an taobh eile fillte.
- Hip / Suíochán- mban
Measure straight across hip, ó thaobh huaire go taobh huaire, 22cm(8 1/2") faoi bhun seam waistband.
- Hip / Suíochán- fir, buachaillí ’agus cailíní’
Boys’ and Girls’ :Measure across hip about 6cm(2 1/2")above crotch.
Men’s: Measure across hip about 8cm(3") above crotch.
- Trunk
Measure from center of right shoulder around crotch back up to center of right shoulder.
- Thigh
Leagan cos cothrom, then measure straight across at top of leg, from side fold at inseam to side fold at outseam.
- Glúin
Tomhais mar Uimh. 6 “thigh” but at the following locations below the crotch seam:
Men’s and ladies’: 5cm(2") less than half inseam.
Example: if 78cm inseam then 39cm-5cm=34cm
Boys’ and Girls’: 4cm(1 1/2") less than half inseam.
Example: if 64cm inseam then 32cm-4=28cm.
- Leg Opening
Leagan cos cothrom. Then measure straight across cuff from side fold to side fold.
- Inseam
Tomhais ó seam crotch ag inseam go bun an chos.
- Armhole
Measure from natural fold at shoulder along sleeve seam to bottom of armhole seam. But some inspectors measure straight across sleeve top to bottom of armhole binding( lowest point). So need to be specified it is curved way or straight way.
- Bicep/Upper Arm
Lay sleeve flat. Then measure from sleeve fold at bottom of armhole, ag dronuillinn leis an muinchille, straight across to opposite sleeve fold. Some makers do measure down 1” from armhole.
- Cuff Width
Lay the sleeve flat. Then measure straight across cuff seam from sleeve fold to sleeve fold. At the top of knit cuff if applicable.
ach, garments may have knitted cuffs to reasonably tightly fit the wrists. Measure from edge to edge in relaxed and also stretched condition.
-
Sleeve Length from center back neck
Establish center back neck. Then measure from this point across shoulder and down sleeve to end of cuff.
- Sleeve Length from shoulder
Measure from top of sleeve head, at armhole seam down sleeve to the edge of cuff.
- Sleeve Length from side of neck
Measure from neck seam, at shoulder seam join, across shoulder and down sleeve to edge of cuff.
- Shoulder Width
Measure from neck seam to sleeve inset-seam.
- Neck Circumference
Measure from center back neck to front centre along neck line. But some markers/designers/importers measure neck width from side fold of neck to the opposite side fold of neck for easier operating.
Detachable and undetachable hood
- Hood Height
Lay hood flat. Then measure from neck seam straight up to highest point.
- Hood Width
Measure across hood from center fold to front edge at widest point.
